71 BMW 2002 project

1971 BMW 2002 Chassis on rotisserie on 8” castors Rust areas shown on pictures • Powder coated front struts and springs, Bilstein shocks, new spring pads, new top thrust bearings • Rebuilt front four piston calipers, new pads included with mounting spring & pins • New front wheel bearings and seals • New Lug studs (Dorman) • Powder coated front sub-assembly, control arm and locating rod W/ Ireland Engineering Poly Bushings • Ireland Engineering sway bar poly bushing and new sway bar links with poly bushings • Blasted and painted sector box (Zinc Chromate Primer W/ 2 part urethane paint) • New Drag Link and tie rod ends, painted tie rods and, clamps • E10 engine rebuilt by my son – NEEDES DISSASSEMBLIED AND INSPECTED • Stock E10 resurfaced cylinder head with complete valve job W/standard camshaft • Stock intake manifold and rebuilt carburetor W/air filter housing and new filter • New ignition wire set • New distributor with points, condenser, rotor and cap • Long tube stainless steel manifold with adapter for stock exhaust • New exhaust pipe, stock muffler and tail pipe • Resurfaced flywheel, new clutch, pressure plate and throw out bearing, new bolts • New clutch master and slave cylinder W/new hose • New brake cylinder and reservoir • New motor mounts • New starter • Stainless Steel brake lines, new stock flex lines W/ new painted mounting clips • New parking brake cables • New gaskets for cylinder head, valve cover, intake and exhaust + many more • Stock air cleaner housing with new air filter • Standard four speed transmission • Ireland Engineering rebuilt driveshaft W/new universal joints, new rubber mounted center bearing and giubo for short neck differential • New trunk lid • Hot dipped galvanized and then power coated rear sub-frame W/Ireland Engineering poly mounting bushings. • Powder coated rear swing arms with Ireland Engineering ploy bushings. • New bearings and seals for rear stub shafts(not installed) • New rear brake shoes and new brake drums blasted and painted • Rear brake mounting plate and hardware blasted and panted. • New half shaft boots (not installed), haft shafts blasted and painted • Stub shafts blasted and painted • Short neck differential with hanger poly bushings • New rear brake cylinders