Are there any pro's con's to renstalling this hunk of metal / balancer? I already did a SS kit and bent the selector rod to bend around it, so SS kit...
thanks, I'll check there, I also intended to ask about pro's con's of installing the balancer back on the driveshaft / guibo. I put in a SSK but it...
I am reinstalling my diff in my E30 and I upgraded to IE green Diff mounts. Well.. now that I am putting the diff back in (after doing sub frame...
Has any one removed one of these? Bently says to drop the diff a bit then press it out. I have the diff off of the car so it is accesible, but what...
Should the driveshaft guide bushing fit snugly into the guibo or is there suppose to be some gap around the guide bushing? I purchased a...
thanks! Thanks all. Got er Down last night. No broken toes. Used the recommended spots and dropped the subframe, diff and trailing arms together,...
Ok decided to remove the , drive axles to drop the sub frame, just to be sure I did not over extend the cvjoints, guess I will take all the brake...
If I am replacing the trailing arm bushings do I really need to Loosen the drive axle nut? most post and bently seem to indicate to remove the drive...
trailing arm removal If I am replacing the trailing arm bushings do i really need to Loosen the drive axle nut? most post and bently seem to...
actually #17 i got past #3, try try pry pry...i was planning on replacing part #13, and the seal, where the shifterbgoesninto the tranny....along...
additional upgrades I took care of most of what you mentioned, motor mounts are now the TMS with the aluminum cups, all the TMS reinforecments, sway...
I will proceed to replace Thank you fpr the reply, I'll think I will march on with this project and order the green (street) IE sub frame bushings,...
I have a 87 325is, I am replacing the driveshaft and flex disk due to vibrations. Driveshaft is off and new on is here to install, While I am "in...
Separate names with a comma.