Hello there and welcome to the BMW Car Club of America.

If you are a BMW CCA member, please log in and introduce yourself in our Member Introductions section.

2000 323 in limp home mode

Discussion in 'E46 (1999-2006)' started by Bimmerboy7770, Jan 2, 2012.

    • Member

    Bimmerboy7770

    Post Count: 2
    Likes Received:0
    2000 323 that is in limp home mode when the car is turned off it will reset and run fine for a bit.
    The car is a friends she had the mass air, spark plugs, and two injectors replaced i the other injectors do not have the best spray pattern. I checked it yesterday with a scan tool the codes that came up 227 and 228 o2 control limits bank 1 and 2. When i checked yesterday the check engine light was on when she drove it today after a bit it went in to limp mode. When checking the tps with the scan tool it started to buzz pretty loud not sure if that's normal just never had that happen before. Any one have any ideas?
    • Member

    MGarrison

    Post Count: 2,831
    Likes Received:144
    I don't know what triggers limp mode, for starters - but, perhaps... fuel pump(s), coil-packs, or 02 sensors, plus the stuff you've mentioned?

Share This Page