Hello there and welcome to the BMW Car Club of America.

If you are a BMW CCA member, please log in and introduce yourself in our Member Introductions section.

rear turn signal issues 2008 Z4 si

Discussion in 'DIY (Do-It-Yourself)' started by woody99, Jan 27, 2020.

    • Member

    woody99

    Post Count: 9
    Likes Received:0
    light is on on display , found drivers side rear turn signal not working, changed bulb Sylvania 7507 -PY21W, does not work , took it in and out with multiple bulbs does not work, took bulb (working) from other side and put it in still nothing. Any ideas?
    • Member
    • Technical Service Advisor

    charlson89

    Post Count: 2,366
    Likes Received:133
    Check bulb holder and mounting area for burnt contacts. Also checked the wiring connector they can burn as well.
    • Member

    frito

    Post Count: 67
    Likes Received:15
    I'm not sure if the new models have the same issue, but check the wiring loom feeding from the body to the trunk. I know on my model it's a common issue that over time, the constant opening and closing of the trunk causes the wires to snap. I had to solder about half of the wires feeding the back end lights (backup, tail light, license plate, etc.).

    [IMG]

Share This Page