Hello there and welcome to the BMW Car Club of America.

If you are a BMW CCA member, please log in and introduce yourself in our Member Introductions section.

ABS Dash Warning Lights - OBD II Scanner to Clear Fault After Sensor Change?

Discussion in 'E90/E92/E93 M3 (2008-2013)' started by 106598, Mar 21, 2016.

    • Member

    106598

    Post Count: 52
    Likes Received:5
    Hello Everyone!
    Had the ABS lights on my dash come on after rolling over speed bump in my apartment complex. Lights stayed on until I was leaving that evening then they went off. Then the ABS lights came on again about a month back and will not go off. It's a high mileage car(112,000 miles) and the blogs said to change the sensors: front and rear. Did that. So now the question is: Do I need to bring the M3 to a shop where they have an OBDII scanner that works on late model BMW's and have the error removed from the computer thus turning off the ABS warning lights on the dash?
    Ideas?
    Thank You!
    John M. Coates, Jr.
    BMWCCA Member #106598
    • Member

    charlson89

    Post Count: 2,416
    Likes Received:133
    This could be a lot of things causing this light. Yes could be a wheel speed sensor. But before you replace anything I would get the codes read to make sure you are spending the money wisely. Yes you will need a computer that can read the DSC module to get the faults.
    • Member

    106598

    Post Count: 52
    Likes Received:5
    Hello charlson89!
    Thank You for your kind reply. I have already changed out all (4) ABS wheel speed sensors. Will find appropriate independent shop that has proper scanner and let you know what happens!
    Thanks Again,
    John M. Coates, Jr.
    BMW CCA Member #106598

Share This Page