Good advice. With lighting you can always test with the other side bulbs. Intermittant functioning can be either broken filliments in the bulb...
Sure glad my trannie is a GM unit!
Easiest item is the TB. Check it for free movement under the hood. You might want to temporarily disconnect the throttle cable while you do this...
Hmm, what a learning curve! Bentley says to bolt the new sealed bearing unit on to the hub carrier, then press or hammer the wheel hub on to the...
Ok, I will try to use some unorthodox terms to describe the parts involved. The wheel and rotor are attached to a hub which has a flange that...
The bearing is not as you describe because it is entirely sealed to a mounting plate, but the installation is about the same. I figure to have the...
I see what you are suggesiting, however, on the 5-series, the hub shaft that goes nito the bearing is pretty long, about 5-6 inches and it needs to...
I am in the middle of this project to replace the driver's side rear wheel bearing. I used a standard 6" bearing puller to extract the hub from the...
Separate names with a comma.