Actually if you go to realoem.com with your last 7 of your VIN you might be suprised to see what may be available from BMW. You could go to the bmw...
The are aluminum and you could go to a truck stop that has aluminum polishers and have them glazed in a jiffy lol.
Hello, The bleeder screw faces up on the slave cylinder. Alternator requires a separate brown insulated wire double nut fastened onto one of the...
It has been an expensive learning experience and have used the slightly higher than 15w40 mineral oil recommended for the 97 m52 328is. I am using...
Get a BMW dealer or Bimmer shop to scan so you don't throw money/parts at a problem.
The bmw at a dealer or bimmer shop scan tool will tell you.
Hey everybody! :) Well, Five months later I ended up getting all four valves in nr 6 replaced as well as all lifters and ledges to the...
I understand it is a normal trait for an initial noise at start up occasionally, but it darn sure is not normal if the lifters make noise over 20...
Hello Sar67 , If your car is not exhibiting any issues just stay with your regimen. I used a lubromoly engine flush and Liquimoly Ceratek treatment...
E36 lifter noise....Here is a 3 month follow up on the oil additive for those with sticky lifters . It has been three months since I have used Lxxxi...
Thanks for sharing your experience! You might recall the E36 m52 engine has an annoying tendency of having noisy lifters. The car still runs and...
My question is: What are your thoughts, and did I make a mistake doing this?? I was never an advocate of oil additives and this is the first time in...
How have some of you installed your rear trailing arm bearings on your 02`s. My arms are off the car so....I know you dont just slide them in...Did...
Sliding piece Those things have been NLA quite awhile now. I would strongly suggest you look for a complete assembly with the sliders. There is a...
moisture barrier Maximillian imports shipped some to me It is called acella film, and you should be able to order it from them still I think. It has...
Separate names with a comma.
