Thanks. I do have some brake squeal, but only in the morning upon the first 15 min of driving at the last 10’ or so of coming to a stop. Is sounds...
Not quite a technical article, but thought this video was worthwhile: https://m.youtube.com/watch?v=5wYZe6lZ9ec#fauxfullscreen
Thank you for the info. I should have read the CCA Classifieds before creating the thread :) Same day, another member posted an F30 spare that will...
Has anyone had experience building their own spare for the F30 / F31? I’m looking to build a spare for my 2016 F31 328ix. The catch is that with...
Today, the dealership replaced the rear rotors, brake pads, inner hex bolt and hex screw w/collar. All was done under the balance of the factory...
I am having a similar issue on my CPO 2016 F31 w/M Sport brakes I too have the 2-pc rotors. I’ve only have the car for just over 3K miles (33.5k...
Taylored Autobody Boonton, NJ
I was trying to trouble shoot a non-working key fob(s) yesterday in addition to my Comfort Access not working. Changed the battery in the key fob...
Th dealership could not reproduce the codes for me. Went to a local independent and while they saw the codes, they mentioned other factors could be...
Wagon has just under 86K. On 9/16/14 @ 50,773 miles, the dealership replaced all the injectors due to fault codes that showed misfires. After...
Left a vm with the dealership, but no return call. Using a basic diagnostic tool, I received the following DTC I/M P0420 Catalyst Efficiency Below...
Brought my 2010 E61 535xi to the dealership today for a check engine light that had appeared twice over the past two weeks and has since gone away....
Charlson89, Picked the car up this evening. Too late to speak with an advisor, but the paper work noted that the old injectors were series 7....
Charlson89, You were correct. A service advisor left me a voicemail today that said it was the fuel injectors that were bad. I tired to follow up,...
Steven S & Charlson89, Thanks for your comments. Charlson89 - Can you let me know what you are referring to by, "HDP" and "updated parts"? Thanks,...
2010 535i xDrive w/51K miles. Yesterday morning startup (temp in the low 50's) yielded a rough idle which did not smooth out within 1/2 mile. Felt...
Charlson, Thanks for the offset chart link 5 Series E60/61 = PCD 5x120 centre bore 72.5mm and M12x1.5 bolt thread. ET 15-32 Based on the above, it...
Charlson, Interesting link, though I'm not sure if it's what you intended. Nothing about wheels...per say. I looked into the wheels on my 535ix...
Carlson, Would the hub size on the E60/61 be equal to that on an E46? This is where I had the wheels mounted prior. Thought I'd be a shame not to...
Charlson, Is the hub bore different on an E60/61 than on an E39? I have a set of BBS RG-R 734 8.5Jx18 ET:38 and wondered if they could work on my...
Separate names with a comma.