Note: Not responsible for any damage to you or your car, this worked on my car so will work on yours. ***This tutorial assumes you know how to get your car secured on jack stands, if in doubt do NOT attempt this DIY! Tools Need not in pic (4 jacks stands & 2 jacks (1) for a safety catch in case jack stand fail (I saw this happen and will NEVER forget it)....safety 1st). Torque specs: Subframe bolts (65 Ft lbs) Strut bolts (25 ft lbs) Suggestions: I highly suggest a impact wrench. I used a 14MM 12Pt socket instead of a E18 on subframe bolts. If you can source a 3/34" inside diameter pipe you can skip a few spteps...I got tired of looking for one...I got each bushing out in less than 15 mins. Note: I was in the middle of a wavetrac install so my exhaust and differential where not in place, You may have to unbolt half shafts...I will update thread in a day or so. Rear bushings:
Front bushings: Click this link before beggining for correct orientation (thanks to "SteveAZ" for bring this to my attention) http://www.powerflex.co.uk/i/product_images/5-420fi.pdf Reference pic of diameter of rear subframe bushing"